Fan Controller

$124.00

  • Item No: FANCTRL1

 

 

Download Product Related Documents:

 

 

Mounting Template

 

Installation Manual

 

 

 

 

Add to Cart:

Fan Controller

for:


Street Rods
Kit Cars
Resto-Mods
Muscle Cars
Pro-Touring Cars

 

 

Most other fan controllers require you to use a temperature sender that screws into the manifold and replaces the sender for your temperature gauge (if your manifold only has one sender port, what do you do for a temperature gauge?). Others require you to insert a temperature probe into the fins of the radiator and routing the probe leads around the shroud.

 

Our compact, all solid-state unit controls a radiator fan using a simple easy-to-install temperature sensor that mounts under a thermostat housing bolt. The controller is short circuit, overload, and reverse battery protected and can be mounted under the hood or inside the vehicle cabin. It also features automatic detection and indication of Temperature Sensor fault conditions. In the event that a sensor fault is detected, the Fan will turn on and run continuously in fail-safe mode to prevent engine over-heating.

 

The intelligence built into the contoller monitors the engine temperature as well as the temperature rate of increase in order to provide efficient on-demand cooling. The benefit of this efficiency is prolonged life of both the Fan and Alternator.

 

An A/C Request input allows the Fan to run anytime the air conditioner is operated, regardless of engine temperature, cooling the A/C condensing coil in cold start conditions before the engine gets warm enough to trigger the fan.

 

 

 

Key features:

 

 

•  Modern, high quality, all solid state design.

 

•  Easy to mount Temperature Sensor mounts under thermostat housing bolt.

 

•  Controls one or two fans, up to 30 amps continuous total load, 80 amps inrush/startup.

 

•  190 deg typical turn on temperature can be reduced or increased.

 

•  A/C request allows air conditioning to operate immediately following cold engine starts.

 

•  Detects temperature sensor faults and turns on fan for fail-safe operation.

 

•  Weather resistant design allows mounting inside or outside the vehicle cabin.

 

•  Reverse battery, short circuit, and overload protection.

 

•  10-32 Studs for solid high current connections.

 

•  Super Compact size measures only: 3.7" x 2.6" x 1" (LxWxH) makes mounting easy.

 

•  Mounting base and cover are powder-coated satin black.

 

 

 

 

 

What’s included:

 

 

•  Control Unit

 

•  Temperature Sensor with 4 ft cable

 

•  Hardware package with nuts, terminals, heat shrink tubing



Customers who bought this product also purchased...